View  Order

OMC / Johnson / Evinrude

Check Out


Misc. Sealers & Hardware   Boyesen Power Reeds Troubleshooting

Installation of Stator 113-8362

  This information was packed with Stator number 113-8362.  The Wiring codes could be different on other stators. These products were designed to be installed by a professional marine mechanic. cannot be held liable for injury or damage resulting from improper installation, abuse, neglect or misuse of this information or products.


Discoloration of all the battery windings is an indication of a problem in the rectifier / regulator circuit. Discoloration of only one post of the battery windings indicate a problem in the Stator.


This Unit does not have a tachometer drive circuit. Motorola and Delta / Wabash amplifiers are replaced by this CDI Universal pack. all clipper modules, surge suppressers and safety circuits should be removed. After removing, be sure the Ignition (red/purple) Wire is connected directly to the Ignition switch terminal.   Failure to remove these items could void the Rapair warranty. all battery CD ignitions include a new Ignition coil.

More instillation instructions are in the part package.

NOTE: When you turn the Ignition on, you may hear a high pitched whining noise coming from the CDI module. This is normal depending upon the battery voltage.

Click here for Complete Electronic Troubleshooting Information and Guide.

Return to Previous page

Troubleshooting Stator 173-1235 Troubleshooting Stator 113-8362
Troubleshooting Stator 173-3668 Troubleshooting Stator 113-7123
Troubleshooting Stator 173-4287